User's guide
In the following sections you will find tips on how to get the most from your EZOORD, troubleshooting and instruction manuals.
Tips
Start-up
To hold the bike with the Ezoord stand:
- Rotate the arm and leave the clamp facing up.
- Raise the column to secure the bike.
- Bring the stand closer to the bike and rotate the clamp to the anchor position.
- Lower the column to the anchor height of the frame or seatpost.
- Secure the bike with the clamp and press the memory button.
Saving your favorite positions in the memory buttons of the controller
With the manual control of the bicycle lift placed on the tray, you can memorize the position in which you work most comfortably.
- Place the elevator in the position you want to memorize.
- Press and hold the M button until the code: S – appears on the display.
- Press button 2.
- The code: S -2 will appear on the display.
- Press the M button again and the height will be memorized.
- If you want to change the position, just repeat the steps as many times as you need.
Warnings and best practices
No maintenance required (do not grease, do not tighten screws, etc.) in case of doubt follow the torque and other indications in this technical guide.
Main features
Take a look at this video, in which we tell you about the main features of EZOORD lifting brackets.
Troubleshooting
Display of code E1 - RES on the control unit display
If the display shows the message “E-1” or “rES” we will have to reset the system. To do this, simply press “down arrow” to the minimum position as shown in the video.
Warning: Reset the unit only in cases of system lockout in which it has been tried before to reset the system by unplugging and plugging in the electric lift.
Warning: The anti-collision function is not enabled during all restarts. Please note that there is a potential risk of getting trapped in this case, and make sure that there are no obstacles in the path of the column.
Replace display control
Watch the following video to see how easy it is to replace the EZOORD display controller.
Replace the crank handle
You will discover how simple it is to replace the crank located on the elevator clamp, through the video below.
Tool-tray replacement
In case you want to replace the bikelift tray, watch the following video in which we explain the steps to follow.
Remember that the bottle holder has a magnetic attachment so that you can place it where it is most convenient for you.
Change from cable to battery version
Take a look at the video, where you will see how to install the battery to a cable version EZOORD lifting stand.
Display of DUTY code on the control panel display
If the message “dut” appears on the display, you should pause. To do this, we recommend that you turn off the bikelift and turn it on again and wait a couple of minutes.
Pedal replacement
In this video we show you all the steps to follow to replace the elevator pedal.
Changing the grippers
Watch the following video to find out what to do when changing the rubber bands on the bikelift clamp.
For anything you need, you can get in touch with us
Whether for technical or other reasons, you can contact the EZOORD team, whose specialists will be happy to assist you.
